INOX SEAL®

High Strength

Innovative product for sealing and securing stainless steel pipes, push fittings and threaded joints.

INOX SEAL possesses good resistance against chemicals, solvents, liquid gas, water and hydrocarbons.

Areas of Application

Production facilities, trade and industry, arts and crafts, railings and staircase manufacture, food production machinery, heating and sanitary installations, water and waste treatment works, marine and racing etc.

Application Examples

  • Bonding push fittings and pipes made of stainless steel.
  • Sealing pipes and threaded joints in gas, water and heating areas.
  • Additional sealing of threaded fittings in the marine sector.
  • General securing of stainless steel threads and other materials in heavy duty applications such as stud bolts, nuts, screws, pipe and drive fittings.

Size / Art. Nr.

Size 20 ml 50 ml 250 ml
Art. Nr. 10 3760 02 10 3760 03 10 3760 04

Base Dimethacrylate Ester
Viscosity (cps) 1250 – 4250 @ 25°C
Specific Gravity 1,15
Maximum Thread-Ø 1½“ (M36)
Gap Fill (mm) 0,20
Flash Point (°C) > 100
Working Time (min) 4 – 6
Functional Time (hours) 1 – 3
Final Cure Time (hours) 24
Breakaway Torque:
(3/8 x 16 steel nuts & bolts)		 11 N.m
Prevail Torque:
(3/8 x 16 steel nuts & bolts)		 14 N.m
Temperature Resistance (°C) -55 to +150
Technical Data
Safety Data Sheet

INOX SEAL

Stainless Steel Bonder

Special Features

  • Protects metal threads against oxidation and corrosion.
  • Shortens the installation and repair time and eliminates the need for elaborate sanding.
  • Suitable for metal fittings with or without threads.
  • Avoids the blue discolouration caused by welding.

Instructions for Use

The surface should be clean, dry and free of contaminants such as oil or grease. Shake product well before use.

Assembly

Screws and Fittings:
It is recommended to use enough product to ensure that the threads or gaps are sufficiently filled. (Pipes or push-in fittings should be roughened with sandpaper beforehand).

Pipe Fittings:
Apply the product to the thread in a 360° ring, while leaving the first thread free. Ensure that the spacing between the threads is sufficiently filled. For coarse threads it is also recommended to apply the product to the internal thread. Tighten the connection as usual and remove any product residue. Properly tightened connections have an immediate sealing effect against low pressures.

Disassembly

Heat the joint locally to approx. 250°C and disassemble while warm.

Storage

Anaerobic products must be stored unopened in a cool and dry room at a temperature between 8°C to 28°C. The shelf-life of these products is at least 1 to 2 years (in accordance with the above mentioned storage conditions). Product residues should never be filled back into the original container in order to maintain the original product properties.

Additional Information

  1. Assembled connections should not be realigned. Should it be necessary to remove the fitting, the joint should be removed and cleaned completely. The joint can then be re-assembled with a new product application. This product, along with other liquid or anaerobic sealants on the market, is not allowed in Germany for gas housing installations as per DVGW-TRGI 2008, as a realignment of pre-assembled threaded joints is not possible. Identification: Not allowed in Germany for gas housing installations.
  2. These products are not suitable for pure oxygen and/or oxygen systems and should not be used as a sealant for chlorine or strong oxidizing media. Cracks can occur when used on thermoplastic materials. It is recommended to check the compatibility with such materials.