SHRINK CONNECTOR

Heat-Shrink Connector

Heat-shrinking impact connector with thermoplastic insulation and internal hot melt adhesive. Ideal for the production of compounds, which must withstand particularly adverse environmental influences. The connectors have excellent resistance to abrasion, as well as high strain relief. Shrink Connector prevents voltage loss and can be used for flexible and massive conductors.

Size / Art. Nr.

0,25 0,5
Gr. 1
0,5 1,5
Gr. 2
1,5 2,5
Gr. 3
4,0 6,0
Gr. 4
Art.-Nr. 55 0001 00 55 0002 00 55 0003 00/td> 55 0004 00

Basis Outer Wall / Inner Wall: Polyolefine / Thermoplastic Adhesive
Crimp Sleeve Copper
Colours cream/transparent, red, blue, yellow
Wire Diameter Transparent: 0,25 – 0,5 mm²
Red: 0,5 – 1,5 mm²
Blue: 1,5 – 2,5 mm²
Yellow: 4,0 – 6,0 mm²
Size:
(Ø min. x Length max.)		 Transparent: 1,0 x 26 mm
Red: 1,6 x 35 mm
Blue: 2,2 x 36 mm
Yellow: 3,4 x 42 mm
Spec. Volume Resistance 1015 Ω x cm
Stability >25 kV/mm
Installation Temperature +180°C (minimum)
Permanent Temperature -55°C bis +125°C
Technical Data

SHRINK CONNECTOR

Heat Shrink Connector

Special Features:

  • Connecting and sealing in just one operation.
  • Excellent protection against corrosion, UV rays, water, chemicals and acids.
  • Design with pressed center for exact cable insertion.

Application Areas

Electrical engineering and information technology, telecommunications, heating construction, plant construction, elevator and conveyor systems, equipment and mechanical engineering, motor vehicles, municipal technology, trailers and caravan construction, lighting and control cabinet construction, swimming pool construction, boat technology and racing, …

Application Examples

  • Cable splices and shield connections
  • Installation of trailer couplings
  • Installation and repair of electrical systems
  • Extension of cables in masonry
  • Installation of illuminated advertising and outdoor lighting
  • Waterproof installations on outboard motors

Instructions for Use

The product should best be processed by means of crimping pliers with double pressing and a hot air blower. 1.) Strip the cable to 5-8 mm. 2.) Slide the conductor into the metal sleeve and press the SHRINK CONNECTOR with the crimping pliers. 3.) Heat the joint evenly around it until the glue at the ends leaks. After cooling, the connection should be checked for its tightness.