Zyrobond Gasketing Compound

AN 3573

Semi Rigid

For sealing tight fittings between rigid metal surfaces and flanges.

  • For gaps between 0.01 mm and 0.20 mm.
  • For sealing motor housings, drive housings and differential and axle housings.
    The product possesses an immediate sealing effect against low pressures.
  • Gap Fill: max. 0,20 mm
  • Working Time: 6 – 48 Std.
  • Temperature Resistance: bis +150°C

Size / Art. Nr.

Size 50 ml 250 ml
Art. Nr. 10 3573 03 10 3573 04

Strength Semi Rigid
Fixing Time (hrs) 6 – 48
Cure With Activator (min – hrs) 60 – 6
Viscosity (cps) 19000 – 60000
Gap Fill Maximum (mm) 0,20
Thread-Ø Maximum (mm) –
Thread-Ø Recomm. (mm) –
Compression Shear Strength (Nm²) > 1,5
Temp. (°C) 150
Specific Gravity 1,25
Technical Data
Safety Data Sheet

Gasketing Compounds

Anaerobic adhesives for sealing metal surfaces, flanges and housings.

Special Features:

  • Prevent friction.
  • Protect against pressure and temperature fluctuations, vibration, impact and load transfer.
  • Prevent fretting corrosion.
  • Bridge large tolerances.

Instructions for use

The surface must be clean, dry and free of contaminants such as oil or grease. If the material consists of passive metal, or if the cure is too slow, an activator should be used.

Assembly

Apply the product manually as a continuous track or by laminar screen process onto one flange side. The flanges or surfaces should be tightened immediately after joining together in order to avoid product structure splitting.
These products allow a low-pressure impermeability test immediately after installation.
Properly tightened connections possess an immediate sealing effect against low pressures.

Disassembly

Use a light rubber or plastic hammer to strike the sealed joint at a 90° angle to the sealed surface (direction “open“).

Cleaning

Lay the cured product in solvent and then mechanically remove the residue.